Airport freight and cold chain · Miami-Dade

Rack Installation and Repair in Miami, FL

Miami warehouses run tight. Conveyor Tek provides rack installation and repair Miami freight and cold-storage operations rely on when every pallet position counts: new racking set to your loads, and damaged steel swapped out before it becomes a bigger problem. It all runs through our pallet rack installation and repair service.

We are family and veteran-owned, based in Lakeland, with owner Todd Bixby working in material handling since 1997.

Long rows of stocked pallet racking in a large warehouse

Racking Systems for Doral and the Airport West Corridor

West of MIA, along NW 25th Street and both sides of the Palmetto, freight forwarders stack everything from auto parts to electronics bound for Latin America. Space is expensive, so warehouse racking installation here has to squeeze out every position without choking the aisles.

Our racking system installation starts with your pallet sizes, lift truck reach and clear height, then we set frames, anchor them and hang beams level. Our rack installation crews also add wire decking, flue spacers and end-of-aisle guards, which matter a lot in a building where trucks turn hard and fast.

Pallet Racking in Miami Cold Storage and Perishables Rooms

Most of the fresh-cut flowers sold in the U.S. come in through Miami, along with a steady stream of seafood and produce. That freight lives in coolers, and cold rooms are hard on racking. Condensation at the dock doors rusts base plates, and frozen-floor traffic is rougher on uprights.

  • Base plate and anchor checks where condensation collects
  • Rack beam replacement on levels that have been overloaded or bent
  • Column guards in front of high-traffic aisles

Much of the rack installation and repair Miami cold storage needs gets done during slow hours, so the cooler stays cold and the product stays on schedule.

Bent Upright Repair for Busy Miami Distribution Floors

Forklift strikes are a daily risk when aisles are narrow and shifts are long. Rack upright repair means replacing the damaged section or the full frame, not pushing the steel back into line. Our racking repair technicians show up with matching parts, so pallet rack repair and other warehouse rack repair usually puts the bay back in service the same visit.

Until then, empty the hit bay and the two beside it, rope off the aisle and do not let anyone reload it. If you landed here after searching rack repair near me from a Miami-Dade loading dock, call us with photos and we will talk you through it before the truck leaves Lakeland.

Pallet Rack Reconfiguration When Miami Freight Changes

A new customer, a new carton size, a seasonal surge before Valentine's Day or the holidays. Freight changes faster than racking does. Pallet rack reconfiguration moves beam levels, adds or removes bays and updates load signs so the rack fits the work again. It is often cheaper than buying new steel, and a good chunk of rack installation and repair Miami 3PLs book with us starts right here.

Miami Rack Audits, Mezzanines and Conveyor Work

Plenty of operators book a walk-through before hurricane season starts in June, while things are calm. Rack audits in Miami cover every upright, beam lock, anchor and load sign, and you get the findings in writing. Your insurance carrier may ask for that report, so keep it handy. The full process is laid out on our rack audit service page.

We also put in steel mezzanines when floor space runs out and handle conveyor service and repair for the lines that feed your racks.

What Miami Operators Get From a Family and Veteran-Owned Rack Contractor

Miami has no shortage of contractors. These are the reasons warehouse managers keep our number for rack installation and repair Miami jobs.

  1. You talk to people who do the work

    Conveyor Tek is family and veteran-owned. Questions get answered by someone who has installed racking, not a call center.

  2. Nearly 30 years on warehouse floors

    Todd Bixby has been in material handling since 1997, across racking, conveyors and mezzanines.

  3. Replacement, not patchwork

    Damaged uprights and beams get new steel, so repaired bays carry their rated load.

  4. One trip, parts on the truck

    Miami is a planned run from Lakeland, so we confirm sizes and load the parts before we roll.

Rack Installation Across Miami-Dade, From Doral to Opa-locka

We cover the warehouse belt that wraps around the airport: Doral, Medley, Miami Springs, Miami Gardens and Opa-locka, plus the older industrial blocks closer to downtown. Searching pallet rack installation near me from anywhere in that ring gets you the same crew and the same answers.

Right next door we handle Hialeah rack installation and repair, and up the coast the shop also runs racking work in Jacksonville.

  • Miami
  • Doral
  • Medley
  • Miami Springs
  • Miami Gardens
  • Opa-locka

Miami Rack Installation and Repair FAQs

  • How fast can you get a crew to Miami?

    We drive down from Lakeland, roughly three and a half hours on the Turnpike. Call (863) 877-7971 between 8am and 5pm any day, or use the 24-hour emergency line, and we will give you an honest arrival time.

  • Do you work in coolers and freezers?

    Yes. We install and repair racking in cold rooms and pay extra attention to base plates and anchors where condensation causes rust.

  • What should we do after a forklift hits a rack?

    Unload the damaged bay and the bays on both sides, keep people out of the aisle, and call us. Do not try to straighten the steel.

  • Can you install racking in a Doral warehouse we just leased?

    Yes. We plan the layout around your pallets, trucks and clear height, then install, anchor and level everything. Send a floor plan if you have one.

  • Is it cheaper to reconfigure our racks or buy new ones?

    Often reconfiguring is cheaper. Moving beams and re-spacing bays can fit new freight without new steel. We will tell you which way makes more sense.

  • When should Miami warehouses schedule a rack inspection?

    Once or twice a year for busy buildings, after any reported strike, and many operators like to book one before hurricane season starts.

  • Do you replace bent beams?

    Yes. Bent, twisted or dropped beams are replaced with new ones matched to your system, along with any missing safety locks.

  • Can you also service our conveyors?

    Yes. We handle conveyor service, repair and installation, mechanical and electrical, plus mezzanine installation and repair.

Line Up Miami Rack Repairs Before the Next Busy Season

Send us photos, the rack brand if you know it and the number of damaged bays. We will quote rack installation and repair Miami crews can finish in one trip.

(863) 877-7971 Send photos of the damage

Open 8am to 5pm, seven days. 24-hour emergency line.